THERMAL SCIENCE

International Scientific Journal

Shuguang Ti

,

Wenwen Chang

,

Zhi Yang

,

Jinfeng Li

,

Feng Huang

,

Shanshan Deng

,

Songzhen Tang

,

Haopeng Wang

NUMERICAL SIMULATION STUDY ON THE FLOW AND HEAT TRANSFER CHARACTERISTICS OF NANOFLUIDS UNDER LOW PRESSURE DROP CONDITIONS

ABSTRACT
This research examined the synergistic enhancement mechanism of nanofluids and hollow single-pitch twisted tapes within heat exchange tubes through numerical simulation analysis. Thermal performance of Al₂O₃, ZnO, and CuO nanofluids under laminar flow conditions was assessed. This study focused on investigating the changes in heat transfer coefficient and friction coefficient under low Reynolds number conditions by keeping the geometric parameters of the twisted tape fixed and altering the nanofluid type, concentration, and inlet temperature. Results demonstrate raising the inlet temperature can enhance the heat exchanger's efficiency, particularly once the Reynolds number surpasses 1000, as the inlet temperature on the heat transfer coefficient. In addition, the composite enhancement structure using nanofluids significantly improves heat transfer performance. Compared with a pure water solution, the heat transfer coefficient increases substantially by 16% to 31.6%. Nanofluids at high concentrations show decreased friction coefficients; however, the pressure drop is greater than with pure water with a range not exceeding 10.03%. Thus, despite heat transfer enhancement, the incurred energy efficiency loss needs to be accounted for. The novel composite enhanced heat transfer strategy proposed herein integrates nanomaterials and single-pitch twisted tape geometry. It offers theoretical support for designing optimized heat exchangers, specifically for low Reynolds number applications.
KEYWORDS
nanofluid, Single-pitch hollow twisted tape, laminar flow, enhanced heat transfer
PAPER SUBMITTED: 2025-10-29
PAPER REVISED: 2025-11-15
PAPER ACCEPTED: 2025-11-21
PUBLISHED ONLINE: 2026-01-17
DOI REFERENCE: https://doi.org/10.2298/TSCI251029242T
REFERENCES
[1] Dewan, A., Mahanta, P., Raju, K. S., & Kumar, P. S. (2004). Review of passive heat transfer augmentation techniques. Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 218(7), 509-527. doi.org/10.1243/0957650042456953
[2] Bergles, A. E. (2002). ExHFT for fourth generation heat transfer technology. Experimental Thermal and Fluid Science, 26(2-4), 335-344. doi.org/10.1016/S0894-1777(02)00145-0
[3] Eiamsa-Ard, S., Thianpong, C., Eiamsa-Ard, P., & Promvonge, P. (2009). Convective heat transfer in a circular tube with short-length twisted tape insert. International communications in heat and mass transfer, 36(4), 365-371. doi.org/10.1016/j.icheatmasstransfer.2009.01.006
[4] Samruaisin, P., Wongcharee, K., Chuwattanakul, V., & Eiamsa-ard, S. (2020). Silver-water nanofluid flow and convective heat transfer in a microfin tube equipped with loose-fit twisted tapes. Journal of Thermal Analysis and Calorimetry, 140(5), 2541-2554. doi.org/10.1007/s10973-019-08984-1
[5] Nagarajan, P. K., Mukkamala, Y., & Sivashanmugam, P. (2010). Studies on heat transfer and friction factor characteristics of turbulent flow through a micro-finned tube fitted with left-right inserts. Applied Thermal Engineering, 30(13), 1666-1672. doi.org/10.1016/j.applthermaleng.2010.03.025l
[6] Jafaryar, M., Sheikholeslami, M., & Li, Z. (2018). CuO-water nanofluid flow and heat transfer in a heat exchanger tube with twisted tape turbulator. Powder technology, 336, 131 -143. doi.org/10.1016/j.powtec.2018.05.057
[7] Eiamsa-ard, S., & Wongcharee, K. (2018). Convective heat transfer enhancement using Ag-water nanofluid in a micro-fin tube combined with non-uniform twisted tape. International Journal of Mechanical Sciences, 146, 337-354. doi.org/10.1016/j.ijmecsci.2018.07.040
[8] He, Y., Liu, L., Li, P., & Ma, L. (2018). Experimental study on heat transfer enhancement characteristics of tube with cross hollow twisted tape inserts. Applied Thermal Engineering, 131, 743-749. doi.org/10.1016/j.applthermaleng.2017.12.029
[9] Armbruster, S., Stockmeier, F., Junker, M., Schiller-Becerra, M., Yüce, S., & Wessling, M. (2020). Short and spaced twisted tapes to mitigate fouling in tubular membranes. Journal of Membrane Science, 595, 117426. doi.org/10.1016/j.memsci.2019.117426
[10] Li, P., Liu, Z., Liu, W., & Chen, G. (2015). Numerical study on heat transfer enhancement characteristics of tube inserted with centrally hollow narrow twisted tapes. International Journal of Heat and Mass Transfer, 88, 481-491. doi.org/10.1016/j.ijheatmasstransfer.2015.04.103
[11] Eiamsa-Ard, S., Thianpong, C., Eiamsa-Ard, P., & Promvonge, P. (2009). Convective heat transfer in a circular tube with short-length twisted tape insert. International communications in heat and mass transfer, 36(4), 365-371. doi.org/10.1016/j.icheatmasstransfer.2009.01.006
[12] Choi, S. U., & Eastman, J. A. (1995).Enhancing thermal conductivity of fluids with nanoparticles(No. ANL/MSD/CP-84938; CONF-951135-29). Argonne National Lab.(ANL), Argonne, IL (United States)
[13] Chandrasekar, M., Suresh, S., & Bose, A. C. (2010). Experimental studies on heat transfer and friction factor characteristics of Al2O3/water nanofluid in a circular pipe under laminar flow with wire coil inserts. Experimental Thermal and Fluid Science, 34(2), 122-130. doi.org/10.1016/j.expthermflusci.2009.10.001
[14] Chammam, W., Farooq, U., Sediqmal, M., Waqas, H., Yasmin, S., Zulfiqar, F., ... & Khan, S. A. (2023). Estimation of heat transfer coefficient and friction factor with showering of aluminum nitride and alumina water 17 based hybrid nanofluid in a tube with twisted tape insert. Scientific Reports, 13(1), 23071. doi.org/10.1038/s41598-023-49142-w
[15] Panja, S. K., Das, B., & Mahesh, V. (2024). Numerical study of parabolic trough solar collector's thermo-hydraulic performance using CuO and Al2O3 nanofluids. Applied Thermal Engineering, 248, 123179. doi.org/10.1016/j.applthermaleng.2024.123179
[16] Kia, S., Khanmohammadi, S., & Jahangiri, A. (2023). Experimental and numerical investigation on heat transf er and pressure drop of SiO2 and Al2O3 oil-based nanofluid characteristics through the different helical tubes under constant heat fluxes. International journal of thermal sciences, 185, 108082. doi.org/10.1016/j.ijthermal sci.2022.108082
[17] Mousavi Ajarostaghi, S. S., Shirzad, M., Rashidi, S., & Li, L. K. (2020). Heat transfer performance of a nanofluid-filled tube with wall corrugations and center-cleared twisted-tape inserts. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 1-21. doi.org/10.1080/15567036.2020.1841860
[18] Obalalu, A. M., Memon, M. A., Olayemi, O. A., Olilima, J., & Fenta, A. (2023). Enhancing heat transfer in solar-powered ships: a study on hybrid nanofluids with carbon nanotubes and their application in parabolic trough solar collectors with electromagnetic controls. Scientific Reports, 13(1), 9476. doi.org/10.1038/s41598-023-36716-x
[19] Pak, B. C., & Cho, Y. I. (1998). Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles. Experimental Heat Transfer an International Journal, 11(2), 151-170. doi.org/10.1080/08916159808946559
[20] Xuan, Y., & Roetzel, W. (2000). Conceptions for heat transfer correlation of nanofluids. International Journal of heat and Mass transfer, 43(19), 3701-3707. doi.org/10.1016/S0017-9310(99)00369-5
[21] Vajjha, R. S., Das, D. K., & Kulkarni, D. P. (2010). Development of new correlations for convective heat transfer and friction factor in turbulent regime for nanofluids. International journal of heat and mass transfer, 53(21-22), 4607-4618. doi.org/10.1016/j.ijheatmasstransfer.2010.06.032
[22] Vajjha, R. S., & Das, D. K. (2009). Experimental determination of thermal conductivity of three nanofluids and development of new correlations. International journal of heat and mass transfer, 52(21-22), 4675-4682. doi.org/10.1016/j.ijheatmasstransfer.2009.06.027
[23] Guo, Z. Y., Li, D. Y., & Wang, B. X. (1998). A novel concept for convective heat transfer enhancement. International journal of heat and mass transfer, 41(14), 2221-2225. doi.org/10.1016/S0017-9310(97)00272-X
[24] Tao, W. Q., Guo, Z. Y., & Wang, B. X. (2002). Field synergy principle for enhancing convective heat transfer- -its extension and numerical verifications. International Journal of Heat and Mass Transfer, 45(18), 3849-3856. doi.org/10.1016/S0017-9310(02)00097-2
[25] Tao, W. Q., He, Y. L., Wang, Q. W., Qu, Z. G., & Song, F. Q. (2002). A unified analysis on enhancing single phase convective heat transfer with field synergy principle. International Journal of Heat and Mass Transfer, 45(24), 4871-4879. doi.org/10.1016/S0017-9310(02)00173-4
[26] Guo, Z. Y., Tao, W. Q., & Shah, R. (2005). The field synergy (coordination) principle and its applications in enhancing single phase convective heat transfer. International Journal of Heat and Mass Transfer, 48(9), 1797-1807. doi.org/10.1016/j.ijheatmasstransfer.2004.11.007
[27] Zhai, Y. L., Xia, G. D., Liu, X. F., & Li, Y. F. (2014). Heat transfer in the microchannels with fan-shaped reentrant cavities and different ribs based on field synergy principle and entropy generation analysis. International journal of heat and mass transfer, 68, 224-233. doi.org/10.1016/j.ijheatmasstransfer.2013.08.086
[28] Yu, Z. Q., Wang, P., Zhou, W. J., Li, Z. Y., & Tao, W. Q. (2018). Study on the consistency between field synergy principle and entransy dissipation extremum principle. International Journal of Heat and Mass Transfer, 116, 621-634. doi.org/10.1016/j.ijheatmasstransfer.2017.09.044
[29] Zhu, X. W., & Zhao, J. Q. (2016). Improvement in field synergy principle: More rigorous application, better results. International Journal of Heat and Mass Transfer, 100, 347 -354. doi.org/10.1016/j.ijheatmasstransfer.2016.05.003
[30] Moya-Rico, J. D., Molina, A. E., Belmonte, J. F., Tendero, J. C., & Almendros-Ibáñez, J. A. (2020). Experimental characterization of a double tube heat exchanger with inserted twisted tape elements. Applied Thermal Engineering, 174, 115234. doi.org/10.1016/j.applthermaleng.2020.115234
PDF VERSION [DOWNLOAD]
Numerical simulation study on the flow and heat transfer characteristics of nanofluids under low pressure drop conditions

© 2026 Society of Thermal Engineers of Serbia. Published by the Vinča Institute of Nuclear Sciences, National Institute of the Republic of Serbia, Belgrade, Serbia. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International licence