THERMAL SCIENCE

International Scientific Journal

EXPERIMENTAL STUDY ON CHARGE OPTIMIZATION OF R32/R1270 AND ITS ALTERNATIVE PERFORMANCE IN THE QUASI-TWO-STAGE COMPRESSION HEAT PUMP FOR DISTRICT HEATING

ABSTRACT
The effect of refrigerant charge on the system performance of quasi-two-stage compression heat pump (QCHP) with replacement refrigerant of R32/R1270 (15/85 wt%) (B for short) for district heating was studied under nominal conditions based on the self-designed QCHP test system and the feasibility of replacing R22 with B was discussed under variable evaporation temperature conditions. The results indicated that the refrigerant charge showed distinct impact on the COPh, heating capacity and discharge temperature of the system using B. The system with B at the optimal charge of 1.2 kg (Bopt for short) achieved the maximum heating capacity of 7.455 kW and the maximum COPh of 3.35 at nominal conditions. The COPh and heating capacity of both systems with Bopt and R22 had similar trends with the change in evaporating temperature, while their discharge temperatures showed different changes from the heating capacity. Compared to those of R22 system, Bopt system showed improvement in COPh and heating capacity of 9.73%~17.54% and 50.84%~53.40% respectively in the evaporating temperature of -15~-5 ℃, with the distinctly lower discharge temperature. Thus, Bopt has remarkable replacement advantages in the QCHP. The lower discharge temperature highlights the outstanding benefits of Bopt system in the reliable heating at lower ambient temperature and longer service life. This study provides reliable reference data for refrigerant replacement in heat pumps and low-carbon heating.
KEYWORDS
PAPER SUBMITTED: 2025-08-18
PAPER REVISED: 2025-10-09
PAPER ACCEPTED: 2025-10-13
PUBLISHED ONLINE: 2025-12-06
DOI REFERENCE: https://doi.org/10.2298/TSCI250818213J
REFERENCES
[1] Yuan, M., et al., Renewable energy and waste heat recovery in district heating systems in China: A systematic review , Energy, 294 (2024) 130788
[2] Li, Y., et al.,Access to affordable and clean domestic heating: A critical review on rural clean heating transformation in China's Jing-Jin-Ji and its surrounding areas, Energy & Buildings, 323 (2024) 114829
[3] Ning, Z., et al. Research progress of phase change thermal storage technology in air-source heat pump, Storage Mater, 64 (5) (2023) 107114
[4] Yang, Z., et al., Analysis of lower GWP and flammable alternative refrigerants, International Journal of Refrigeration, 126 (2021) 12-22
[5] Wang, B., et al., Numerical study of gas injected heat pump using zeotropic R32/R1234ze(E) mixture: Comparison of two type economizers, Applied Thermal Engineering, 142 (2018) 410-420
[6] Ju, F, et al., Experimental investigation on a heat pump water heater using R744/R290 mixture for domestic hot water, International Journal of Thermal Sciences, 132 (2018) 1-13
[7] Lee, H., et al., Thermodynamic performance of R32/R152a mixture for water source heat pumps, Energy, 40 (2012) 100-106
[8] Tian, Q., et al., An experimental investigation of refrigerant mixture R32/R290 as drop-in replacement for HFC410A in household air conditioners, International journal of refrigeration, 57 (2015) 216-228
[9] Hakkaki-Fard, A., et al., Applying refrigerant mixtures with thermal glide in cold climate air-source heat pumps, Applied Thermal Engineering, 62(2) (2014) 714-722
[10] Chien, L.H., et al.. Pool boiling performance of R32/R290 and R32/R1270 blends as potential alternatives to R410A, Applied Thermal Engineering ,253 (2024) 123733
[11] Yang, Y, et al., Performance Analysis of an R290 Vapor-Injection Heat Pump System for Electric Vehicles in Cold Regions, Science China Technological Sciences (2024)
[12] M, M., et al., Generalized effects of refrigerant charge on normalized performance variables of air conditioners and heat pumps, International Journal of Refrigeration, 76 (2017) 367-384
[13] Wang, Y., et al., Energy, exergy, economic and environmental analysis of refrigerant charge in air source transcritical carbon dioxide heat pump water heater, Energy Conversion and Management, 223 (2020) 113209
[14] Ghoubali, R., et al., Refrigerant charge optimisation for propane heat pump water heaters, International Journal of Refrigeration, 76 (2017) 230-244
[15] Corberán, J.M., et al., Charge optimisation study of a reversible water-to -water propane heat pump, International Journal of Refrigeration, 31(4) (2008) 716-726
[16] Xu, S., et al., Experiment study of an enhanced vapor injection refrigeration/heat pump system using R32, International Journal of Thermal Sciences, 68 (2013) 103-109
[17] Abasa, N., et al., Natural and synthetic refrigerants, global warming: A review, Renewable and Sustainable Energy Reviews, 90 (2018) 557-569
[18] Ji, Z., et al. Experimental study of the integrated vapor injection R1234yf electric vehicle heat pump system in cold conditions, Applied Thermal Engineering, 270 (2025): 126214
[19] Li, Y., et al. Performance study of a quasi-two-stage compression air-source heat pump system with an economizer coupled phase change accumulator, Energy and Buildings, 317 (2024) 114384
[20] Lu, F., et al., Experimental study on thermal performance of transcritical CO2 air source heat pump for space heating, Energy Procedia, 158(2019) 5913-5919
[21] National Refrigeration and Air Conditioning Equipment Standardization Technical Committee. GB/T 25127.2-2020, Low ambient temperature air source heat pump (chilled water) units Part 2: Heat pump (chilled water) units for indoor use and similar applications, Beijing: China Standard Press, 2020
[22] Corberan, J.M., et al., Influence of the source and sink temperatures on the optimal refrigerant charge of a water-to-water heat pump, International Journal of Refrigeration, 34 (4) (2011) 881-892
[23] Pottker, G., et al., Effect of the condenser subcooling on the performance of vapor compression systems, International Journal of Refrigeration, 50 (2015) 156-164
[24] Shen, D., et al., Experimental analysis on refrigerating system performance of a parallel unit with several compressors, Fluid Machinery, 48(9) (2020) 77-82

© 2026 Society of Thermal Engineers of Serbia. Published by the Vinča Institute of Nuclear Sciences, National Institute of the Republic of Serbia, Belgrade, Serbia. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution-NonCommercial-NoDerivs 4.0 International licence